• I'm back on my BS 🤪
    link
    fedilink
    English
    arrow-up
    3
    arrow-down
    1
    ·
    25 days ago

    This is absolutely a safety rule violation that shouldn’t even fit in someone’s head. But, playing Satan’s proponent, what if they were certain the tanks were all empty? Would it still be dangerous?

        • Solemn@lemmy.dbzer0.com
          link
          fedilink
          English
          arrow-up
          4
          ·
          24 days ago

          I could be remembering wrong, but basically any remnants inside are unpressurized, so they’re all vapor, easy to heat since there’s less thermal mass, and ready to light if there’s any oxygen.

        • ironhydroxide@sh.itjust.works
          link
          fedilink
          English
          arrow-up
          3
          ·
          24 days ago

          Because the assumption that there’s no danger, coupled with the fact there’s now oxygen inside the tank, much more likely to be near the flammable or explosive ranges.

          When full or in use you expect it to have fuel in it and usually take more care (obviously the welder isn’t), and if a leak catches fire it then turns into a torch, until the tank overheats and bleve’s (very unlikely that you don’t notice the torch before the bleve)

          The big risk of full is, you might have a steady leak that stays in the area, and then you ignite it somehow. But the likelihood is very low that it would get to the flammable or explosive ratio in open air like this.